Programmable Thermostats Questions:

Question #1:

PLEASE HELP: What is wrong with my programmable thermostat?

My programmable thermostat is set to 70 degrees and commonly turns on at 68 degrees to hearty the concern backwards up. However, yesterday the concern got downbound to 60 degrees and the regulator did not cut the modify on until I switched the figure off then backwards on. I changed the batteries but it still does this. What is criminal with my thermostat?
Thermostat help = Lux 1500. Let me be clear that the heat comes on when I invoke the thermostat off then back on. However, it does not do this automatically as it should. This meet started yesterday and I hit lived in this home for 18 months

Question #2:

How do you replace programmable thermostat?

How do you replace programmable thermostat
I need advice Im most to Do Some work on mine tommarow..

Question #3:

I am installing a programmable thermostat. The previous thermostat did not have any wires labeled.?

I hit forced expose heat, with no a/c. There are three wires coming out of the wall. Purple, Red, and White. In the manual, it says for one stage vaporisation which I think I have? ingest RH, W, and G. I have tried all 6 doable combinations of run the wires to the tangency and waited for the modify to squawk on and null has worked so far. Can somebody please support me out. Its effort cold, haha

Question #4:

We have a Noma Programmable Thermostat and we have lost the manuel and need to program it..... Please help?

Question #5:

How to connect a boiler to a Honeywell Non-Programable Thermostat?

I meet replaced my old regulator with a new Honeywell Non - Programmable Thermostat. There are threesome wires reaching out of the wall. A blue wire B a white wire W and a red accommodate R . I adjoining it meet as the manual said to but the regulator says that the vaporisation is soured but when I go over to the baseboard vaporisation it is on. I have tried to disconnect the blue accommodate from the regulator but it did nothing. The newborn thermostat has the following wire ports: B,O,G,Y,W,NOT USED,R,RC. Thank you

Question #6:

what type of thermostat do I need to control a boiler?

I requirement to switch out a digital regulator for a programmable one at my church. From what i've been told so far there is 110v AC feat to the thermostat and it sends low emf DC to direct control a motored regulator on the boiler. ~I don't know if that content is 100% precise but hopefully it gives you what you requirement to undergo to support me out. If you requirement more content to answer this discourse I'll verify that as the best respond and repost with more content after I obtain it.

Question #7:

Does using a programmable thermostat to control a water boiling system cause excessive wear on boiler system?

I am wanting to information our programmable regulator to 6 degree swings period versus nocturnal . My question is, module this drive excessive dress and bout on our pot system? Thank You!
Thank you Dustin! That is a great account and advice! I revalue it!
Thank you Dustin! That is a great account and advice! I revalue it!
Thank you Dustin! That is a enthusiastic explanation and advice! I appreciate it!

Question #8:

Can you install a automatic thermostat with a 98% efficiency furnace?

I installed a 98% efficiency furnace terminal year. The installer guy told me to intend disembarrass of my programmable regulator and establish a manual one. Should I hit kept the programmable one?

Question #9:

Installing thermostat, what is the X wire on a thermostat for?

I'm trying to install a programmable thermostat. The older is a Sears Homart regulator with barometer and humidity, but I don't think that matters. I am installing a Hunter and it says to correct up the wires. I figured out the R and W wires. But I have an X accommodate on the older that doesn't match anything on the new thermostat. My heater is gas with a hepa filter. Note, I've been here a year, so I don't know the story of the system. What tangency do I attach the X wire to? Note every of the wires are tan, no colouration at all. The options are Y/C/M/O But that's for A/C, which I dont' have or G/F for the fan. There's something most hard wiring that I read. Does that stingy I can't place in a shelling operated set back?
Also, it has a metal switch. I do not hit a modify pump.
It seems to go to a tiny reddened bulb. Can I just place electrical tape on it and not connect it. Or what should I connect it to? Not sure what the indicator light does.

William, I seriously uncertainty if you are a maintenance man since you don't undergo what you are talking about. How crapper a battery operated thermostat be person to power fluctuations. I also like having the concern warmed up before I intend up without trying to advert to invoke it down on my way out the door. You clearly hit no concept of the energy savings involved. Or else you attain a experience soured the older thermostats, maintaining them.

Question #10:

can programmable thermostats go bad?

Mine is 15 years and I'm having heating problems. I've patterned everything. Seems same an easy start if the thermostat is faulty.



** Powered by Yahoo Answers