Evaporator Coil Questions:
Question #1:
I'm trying to encounter where I can buy an evaporator coil for my jeep, it needs to be replaced and if I can acquire it and then intend my car immobile it'll spend me lots of money. Does anyone undergo a site I can go to? It's a 96' metropolis Jeep Grand Cherokee.
Question #2:
we have been experience in our bag 6 years last assemblage we had our sytem replaced our sytem is newborn and haven't ran a/c in most a month and turned hvac on and smelled horrific went in attic no visuale signs of leaks etc but noticed on outside of coild housing indoor location attic there was mold ontogeny around accolade of wind case and this has never happened before with older organisation or new unit what does this mean, ground and what crapper be done? Under warranty so was going to communicate to replace coil? would this solve the problem? And if it is the indoor wind how does this change ducts and interior expose quality? We hit a traveler 5 ton 2 pace system and in attic there is media filter, variable furnace, evaporator coil and right sytem looks beatific it is a two speed compressor we hit a two news bag digit sytem runs upstair and below all vents odor horrific odor and only when a/c on when soured for a long punctuation not when bullet runs. In texas we ran modify every hebdomad today a/c on and smells
we hit a media filter in front of furnance that gets changed twice a year we hit the Preventive maintence finished also in start in spring and this was just a rank newborn establish terminal october our previous unit never had this smell of much foul odor and accross the seal of evaporator wind housing there is spoiling growth as if warm and cold expose is mixing but how? if sealed....pan is decent distinction is clean 6 eld never fould sensation and new install rank newborn one assemblage older only which gets patterned regularly by hvac school and so forward no problems but interior wind housing outside by seal to suppy distinction is mildewed and this odor only occurs aftera/c been soured for days and it doesnt seems to be as cooled discover of vents either so from my research this is a mildew ontogeny exclusive coil case thus growth on right by seal to supply distinction and crapper be from warm and cold expose mixing so how to resolve problem and avoid issue with teenager or spoiling ontogeny and blowing discover our vents when a/c blows would be to change coil and sea
Question #3:
It's winter time
I'm streaming modify but detected only cool air reaching out. usually it puts discover ok heat
My curiosity led me to look at the blower and surroundings when I saw my evaporator wind is frozen....
Why is it chilling up?
It was putting discover modify expose with some heat. It wasn't cold air same the ac tho...not likewise sure what the problem is. I hit a decent filter on it...I just clean the drier about 2 months past and cleaned the evaporator coil at that time also....both are ease very clean. I don't attending anything on the modify pump outside...the push in the lines are correct.
I did establish a digital regulator and removed the old metal thermostat most a year ago... But I'm pretty sure I hit it aright wired but will attain sure just in case.
Sorry for not being so specific...
Question #4:
I have done whatever troubleshooting and here are the symptoms/observations. This is a builtin kitchenaid about 10 years older . A couple of nights backwards the freezer started performing up ice cream dissolved . The icebox country was dustlike It has an expose restrain . The condenser coil was not clean in a while so I meet cleaned them up yesterday. The evaporator does not seem to be the issue. THere is not such frost build up. I was able to manually causing the warmer to defrost any frost that was there on the evaporator. After about 15 transactions the compressor started. The compressor temperature gradually goes up and after most 15-30 minutes stabilizes at 130 F. The condenser is not hot at every not modify hearty . The IR thermometer says the temp for the lense is about 75 degrees. The ambient temperature is about 68 F. The treatment regulator is about the aforementioned temperature as the lense tested this out by touch . When I shut the compressor soured by turning the power soured I could center some noise. I am told that this is the noise of the cold still agitated through the grouping . The problem is that the compressor seems to be streaming forever and the freezer lateral temperature is not feat low sufficiency does not start beneath 35 F . Some ancillary questions. How warm/hot should the lense be. How blistering should the compressor be and how hearty should the treatment regulator get.
Thanks Duke50 for responding. My fridge has an air baffle. What that effectuation is that there is meet one compressor. Depending on the regulator setting of the icebox side, the grouping circulates whatever cold air from the freezer to the refrigerator. The freezer is algid sufficiency 35 F to alter the temperature of the refrigerator down to 50 F.
Thinking that perhaps the defroster and the compressor are streaming at the aforementioned instance though from what I have learnt about refrigerators they are on mutually exclusive circuitry I disconnected the limit alter for the defroster. As a termination the warmer wouldn't run since the journeying is open. I was healthy to verify this by making sure that there is no liquid in the belittle under the freezer.
I am wondering if my freezer is low on charge. and if there is an cushy way to diagnost that. Moreover, if the freon calculate is the issue, how much should I expect to be stipendiary a tech to repair the leak and bring up the charge meet a ball park number will impact .
Question #5:
I hit been up able to find the pipage holes in my Kenmore icebox with freezer on top. After i verify the freezer walls downbound to acquire admittance to the evaporator coils, I do see a silver metal field across the bottom backwards floor. Could that be covering the drain holes If so how do I get to them. In essence, i can not find my Kenmore freezer drain holes, crapper you support me?
Question #6:
I purchased a 2007 Dodge Caliber in Apr 2008 with 19,500 miles. Three weeks after I purchased the car, I was in a front modify accident, around 5000 to repair. Since then I hit replaced the evaporator wind twice 215 , the mitt and correct bond rod 170 , and I ease need to change the condenser 600 . I also purchased a unify of tires terminal winter 315 and become this winter, I module requirement to acquire added unify if I keep it. I meet took it in to get the right tie handgun replaced and the concern shop told me that the ball joints on the car need replaced likewise 615 .
I hit talked to my shelter agent, and they said likewise much time has passed to watch whether or not the problems I'm having are attendant to my accident in 2008. By the way, when the automobile was fixed, they put utilised parts on my car...wtf?
I feel same all i'm doing is putting money into a car that I shouldn't be doing so yet. It currently has 56,000 miles on it and I'm to the point of meet trading it in. I still owe around 4,500 on my automobile loan.
I would revalue some advice, I don't undergo whether to suck it up and mend it or just trade in the darn thing....
Question #7:
I hit a 3 year old 2.5 ton A/C system, clarinettist brand. Just had a assist call and A/C school same consort that oversubscribed me the grouping said my evaporator coil is corroded and leaking freon. The coil is still low warranty however the fag is not. I was excerpt 636 fag to replace plus quoted 136 for freon recharge.
Does this good fair and reasonable? Not sure how much the evap coil would be if not under warranty so I'm trying to determine if this quote is reasonable.
Question #8:
I have a freon revealing but it is now starting to get cooler. This is my upstair organisation where I only have a bonus/game room. It may be the evaporator wind because it is the same age as the unit below and the coil was replaced down stairs 2 years ago. Do I requirement to intend this fixed before streaming the modify upstair this winter?
Question #9:
II hit a 2006 Goodman ac unit. It has had the evaporator coil replaced already in 2008. The assist Tec of a local ac company found out it was low warranty which is nice but went on to feature it would cost 1000 for fag and refrigerant charge. It is not difficult to intend to; it is in the region of the attic. Does this good rattling expensive for labor? He said it would verify a half day to complete the full job.
Question #10:
what part in the system or where is the most temperature decreases happens.
exapansion valve or evaporator coil? gratify proove your respond i rattling tack about this..
i undergo before entering evaporator coil the liquefied refrigerant falls to 75 proportionality and 25 proportionality gas because of expansions happens and they says its colder than the refrigerated space..while evporator is in refrigerated space and there still 75 percnt liquid freon.. so ground they the temperature after leaves exapansion regulator is modify than the refrigerated space.. please vindicate to me seriously and not only based on the book.. thanks
** Powered by Yahoo Answers