Deep Well Water Pumps Questions:

Question #1:

How hard is to maintain a saltwater pond.?

I hit a well that pumps almost seawater, this can be utilised to filll my empty pond that i have. The lake is 70' X 70' and most 10' deep, stuff it will not be a problem. What would it take to maintain the water and what category of fish would i be healthy to have.

Question #2:

should I get a powerhead for my tank?

I hit a 30 congius cube tank and I see like it needs a powerhead. Well not needs to but it strength be better. I hit a tetra 2-10 gallon internal separate which I had in my 10 gallon tank before it small and does almost null because its at the top. I also hit a tetra power separate for 20 congius cell that one provides more water line but lots of the waste builds up in a crossway because the separate are not deep enough to garner them up so are there spreading tubes for the tetra outside filter. I also hit an air viscus that gives more water flow. The tamk contains live plants only and platies that are diminutive same this:_________________ so is it okay do they like liquid line broad or low module it stress them out? there is a big urn smash decoration for them to hide and added small cave. But would a powerhead be a beatific idea. And how unfathomable in hhe glass crapper younput the power head? I poverty my tank to be crystal clear with no waste at the bottom. My tank is new so its cloudy but its been foggy for a some day should I be concerned and dont worry its cycled both filters came from a cycled 10g tank.

Question #3:

Physics Electricity Help Please?

An automobile locomote drives a pump that lifts liquid from a well that is 11.9 m unfathomable and then delivers the liquid finished a tubing at a evaluate of 180 L/min and a speed of 21.0 m/s. If we assume 100% efficiency and ignore viscosity, the underway worn by the locomote from a 220-V maker is

Question #4:

Water from an underground spring. how do i find it? how do we stop it? we have well water. ?

we hit a sump viscus which never stops streaming /- 1gpm .how do you watch where the spring is? I would same to entertain it absent from the house. also, we hit well water. I was told the well is 10' deep. is this a problem as well?

Question #5:

deep well not working, please help?

good afternoon...my well is not pumping any water. i was gone for the weekend and there was a power outage. when i returned home, i could center from the route somthing was wrong. the pump was running and sounded high pitched. there is NO push building and i know that it is not a push switch issue since it not building any!

i thought it might need priming, but when i removed a cap it was already full...tired of asking grouping that dont have a clue..so i hit lived without water.

everyone i ask, assumes i am an idiot and i jus need a newborn switch! but it sounds same its enternal??

Flotec 1 HP Deep-Well Convertible Jet Pump
Model # FP4332

its the 3rd digit in 10 eld that i bought at bag depot yes a some years past i replaced every the pipes and foot!

Question #6:

Gas bill 443% (4 times higher) same time last year - how to resolve?

We discovered that our pot was making loud noises - like it did not have sufficiency water. It unsuccessful completely so we got the pedal man discover to fix it. He "pumped it up" and the harry went from red to green. He seemed astonied when I told him that it had been "pumped up" a few months earlier. Well, within a hebdomad its display the aforementioned problems.

I am worried because I meet gave a meter reading to EON and our bill is HUGE. Way more than our direct entry crapper cover. Their tracker shows we utilised 443% as such pedal as aforementioned instance terminal assemblage - when we had unfathomable snow throughout most of the time!

Will EON revise the bill or am I in for a fisticuffs with the gas grouping / whoever? What module hap and what crapper I do to maximise my chances of not getting screwed.
There is definitely a mistake.

We had an electric descent fitted this year, so no water heated up for showers / baths.

This instance last assemblage we had deceive and ice and this year it hasn't gone beneath 1 degree. Rarely been below 4 c outside.
I absolutely conceive the boiler is to blame as it makes noises same a kettle with scarce some water in. As a layman - and using the principle of occam's razor - I staleness adopt that the noisy pot which has been seen by an organise twice in the past 4 months is existence told to heat the water and is not cooking enough liquid to modify the house. So the radiators don't heat the house and the regulator does not tell the boiler to stop.
If the boiler didn't drive the calculate to quadruple - what did? We haven't been streaming the heating devilishly and we had an electric descent fitted. How crapper the usage be higher?

Question #7:

How do I turn on my water from a deep well pump?

Question #8:

Groundwater Basics Practice Quiz?

1.Which common, rock-forming mineral or mineral assemble is most pronto dissolved by groundwater?

A.calcite


B.feldspars


C.quartz


D.clay minerals

2. A course is said to be continual and effluent when ________
A. downfall is much that the water plateau remains constant throughout the year
B. the steer bottom and the liquid plateau are constantly at the exact aforementioned level
C the steer is above the topical liquid plateau year round
D the local water plateau is above the steer bottom year round

3.The water table is ________.
A.an underground mass of partly supersaturated rock

B.a bounds between dull bedrock and an subsurface river
C.a boundary between saturated sway beneath and unsaturated sway above
D.a bounds between dull bedrock beneath and supersaturated bedrock above

4.________ controls the assist or difficulty of groundwater transmission finished a porous material. A.Portability
B. Permeosity
C. Potability
D. Permeability

5.________ are characteristics institute in every good aquifers.
A.High porosity and broad permeability
B. Low body and low permeability
C. High potability and broad portability
D.Low porousness and high potability

6. A alert water plateau develops when ________.


A. a horizontal aquitard above the regional water table lies below an aquifer
B. an aquitard beneath the regional water plateau lies above a horizontal aquifer

C. an aquifer beneath the regional liquid table is underlain by a flat aquitard
D an aquifer above the regional liquid table is overlain by a flat aquitard

7.An flowing substantially is digit in which ________.
A. pressurized groundwater rises from a deep, unsaturated aquifer
B. the well is horizontal and the liquid plateau is perched
C. the water is warm, fairly saline, and recharged by an loaded stream
D. liquid rises above the crowning of the aquifer without any pumping

8. Excessive groundwater withdrawals crapper drive ________.
A. Expansion of the dewatered aquifer.
B.An influent course becomes an effluent stream.
C.Porosity in the aquifer increases as the liquid is removed.
D. The liquid table drops or declines in elevation.

9.An aquifer is ________. A. a saturated, porous, and semipermeable layer or stratum
B. a layer or stratum in which groundwater flows descending to the water table
C.the porose and permeable, saturated strobile of depression in an aquitard
D. an unsaturated, influent-flow bottom or stratum below a spring

10.What force pushes groundwater from pore to pore beneath the water table?

A.seepage affluence actor
B.integrated intensity impulse
C.pressure position or hydraulic gradient
D. permeability steepness
11. Which one of the mass concerning stalactites and stalagmites is not true?
A. Stalactites are deposited from liquid flowing from the cap of an aerated cavern.
B. Both are composed of metal carbonate.
C. Stalagmites modify on the floors of caves below the liquid table.
D. Both are forms of dripstone; stalactites hang from the ceiling, stalagmites acquire ascending from the cavern floor.

Question #9:

Could there be something wrong with the check valve in my deep well pump?

Our unfathomable well viscus was cycling on and soured about every 40 seconds. The substantially is 250 ft. deep. Many people advisable debilitating the liquid retentive cell to attain sure it was not liquid logged. We exhausted the tank, put the push to 38 psi. The cycling on and soured ease continued. It stays off for 35 seconds then on for one time and 15 seconds. Then we turned soured the important water inlet valve in order to isolate the pump and the liquid tank from the house. Somone had suggested that on our first question. After we turned off the important water inlet valve to the house, the cycling continued. Any suggestions as to what it could be? If it is a analyse valve, is that something someone could repair on their own?

Question #10:

HELP WITH MATH QUESTIONS?

1.The Rideau Canal is a waterway that stretches from Ottawa, ON to Kingston, ON. It consists of 42 locks that crapper be used to lift or lower boats to road waterfalls and rapids. You can learn more about the Rideau Canal here:
Locks work by placing boats in a chamber, which is a long concrete bet with doors at apiece end. The doors can be unstoppered or winking to earmark boats in and to “seal” the chamber. The chamber can hit water tense in or tense out. As the water take lowers or raises the dish changes peak as well. This allows boats to bypass waterfalls and movement upstream. The modify in height crapper be quite dramatic. For example, the lock station at town designer raises or lowers the dish by 13.7 m using 4 closely settled locks! This vertical change in distance is known as the hair lift height.

a The average chamber size for a lock on the Rideau Canal is 41 m daylong including the doors by 10 m wide, with a depth of 1.5 m nonnegative the lock lift height. The doors at apiece modify of the hair are about 1.6 m thick. If a lock has a lift peak of 2.9 m, what is the intensity of liquid contained in the hair when it is full? 2 marks

b At 4°C, a 1m x 1m x 1m block of liquid weighs most 999.9720 kg. At 10°C, the same block of water weighs most 999.7026 kg. Calculate the disagreement in coefficient for all the liquid in the chambers of the Kingston Mills locks, which consists of 4 locks having a compounded displace height of 13.7 m. 3 marks

c The end of the Rideau Canal is in Kingston, Ontario. It’s defended by Martello towers, a represent of which crapper be found here: A Martello shape is essentially a chamber with a conical roof on top. While a genuine Martello shape is tapered, for our purposes the tower crapper be considered a amend cylinder. The walls are prefabricated of stone, patch the roof is prefabricated of wood. 4 marks

•The Cathcart Tower on Cedar Island 16.5 m in diameter and stands 11 m high, allow the roof which is 1.8 m high and has a humble diam of 18.2. Given that the walls and roof of the shape are 1.6 m thick, what is the interior volume of the tower?
•The shape contains digit cannons, apiece of which blast spherical cannonballs with a diam of 22 cm. What is the intensity of 5 cannonballs?

d The locks are often connected by canals, which are ditches dug to enter bodies of water. Colonel By, the main organise on the Rideau project, needs a supply that is 52 272 ft long. It must hit a carpal cross-section that is 5.5 ft deep and 6 ft across the bottom, with walls sloping superficial at an angle of 50. An older grey buddy of Colonel By’s bids on the project, substance to do it for 0.87/cubic field plus 10% profit. Calculate the test bid. 3 marks

______________________________________…

2. Images on a computer crapper be stored many structure to account for quality and expanse issues. One of the factors we can adjust is colouration depth. Colour depth determines the number of bits we ingest for apiece element of an image. The pixels are the diminutive dots that attain up an image. The higher the colour depth or taste per pixel , the more crisp colours an ikon crapper have. Some standard colour depths allow 2-bit CGA , 4-bit EGA , and 8 bit VGA .

a Given an ikon that is 1024x768 pixels determine the size in bytes of the ikon at CGA, EGA, and VGA resolutions. 2 marks

b An ikon with dimensions of 400x800 pixels is compressed to save space. The shut file is reduced to 76% of the original size, and today measures 972800 bytes. Determine the colour depth of the original image, in bits. 3 marks

c A computer generated sphere is covered with a texture. A texture is azygos image that is repeated many nowadays in order to save memory. Given the orbit has a diameter of 1000 pixels, how some time staleness a 64x64 element ikon be repeated to cover the whole sphere? 4 marks
______________________________________…


3. The render rods for a certain type of thermonuclear setup are bundled into a cylindrical shell. Consider this cross-section display 19 same fuel rods:

a If the diameter of the rounded bomb is 14.42 cm, calculate the crosshatched area of the cross-section. 3 marks

b If the length of the cylindrical bomb is 88.60 cm, what is the volume of the crosshatched expanse around the fuel rods?
3 marks

c What is the volume of a azygos render rod? 3 marks



** Powered by Yahoo Answers